Serviettenapkin Folding Elegant And Easy Food

SERVIETTE/NAPKIN FOLDING,, A SIMPLE ELEGANT CYLINDER

Steps:

• Lay your serviette square out flat before you in a diamond shape. Bring the bottom "South" point up to the "north" point of the diamond shape and you will now have a triangle shape with the crease at the bottom.
• Depending on how big your serviettes are, fold 1 1/2 to 2 1/2 inches (4-7 cm) back undernieth the fold edge of the triangle. The bigger the serviette the deeper this fold will be.
• Take the "east" point of the triangle and start rolling it up towards the "west" point of the triangle. When you get to the "west" edge tuck the "west" edge into to pleat that forms at the bottom.
• Turn the serviette over so that the neat front side is showing.
• A small bloom can be inserted into the pleat at the bottom if you wish.

SERVIETTE/NAPKIN FOLDING, FRENCH PLEAT WITH POCKET

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the original square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the loose edges pointing upwards. We will call this the North corner.
• Take the topmost of these points and make a relatively tight roll towards the South position, at about the half way point you won't be able to roll any further and you will have a diagonal neat cuff going east/west across the diamond shape.
• Now take the next loose corner at North and gently bring it South, tucking it underneath the cuff that you just made in the previous step but leaving a pleat showing above, the same width of the cuff below. You will now have two diagonal neat cuffs/pleats going east/west across the diamond shape.
• Then take the next loose point at North and bring it to the South position, and still holding the point, start rolling it under itself heading towards the North position, at about the half way point you won't be able to roll any further and you will have a third horizontal neat cuff going east/west across the diamond shape that's next to the second one.
• Rotate your diamond shape so that the North point is now the top right corner and you have a square shape in front of you with three diagonal pleats running from the top left corner to the bottom right corner.
• Gently turn the serviette over and bring the top right and bottom right corners into the center. Repeat with the top left and bottom left corners.
• Turn back to the front side and you will have a very neat rectangle that has three diagonal pleats running across it.
• An elegant and stylish serviette that will impress any guest.

STEP BY STEP NAPKIN / SERVIETTE FOLDING

Steps:

• Take your square napkin, lay it totally flat before you, then fold it in half horizontally.
• Fold again, this time vertically so that you have before you a square a quarter the size of your origonal square.
• Only one of the 4 corners will have 4 open or loose edges. Rotate the square before you so that it looks like a diamond with the four open edges pointing to the bottom.
• We will call the points on your diamond shape East, West, North and the open egded bit, South.
• Make a horizontal fold between the East/West points, bringing the open ended South point up to meet, and on top of, the North point.You will now have a little triangle.
• Take the East point of the triangle and fold it in towards the middle. What was the sloping right hand edge of the triangle is now a vertical edge running down the center of the triangle and there is a little flap sticking out at the bottom.
• Take the West point and fold it into the center the same as you did with the previous East edge, the two vertical lines should meet in the middle, and you will have a diamond shape that has two long sides at the top and two short sides (the two little flaps) at the bottom.
• Pick up your diamond shape and fold the two little flap bits at the bottom completely under, so that they only show on the back of the triangle. The front will now look like a steep triangle with a vertical slit down the middle.
• We will call the points of this triangle East, West and North. With the flaps still folded to the back of the tiangle, fold the East and West points backwards until they meet, and gently crease the two folds that form and meet at the North point.
• The slit in the front will have opened and the 4 open points of the napkin will be hidden in layers inside. Pull very gently on them one by one and they will stand up like the sails of a boat. Some people I know call this napkin a boat, some a flower and some the Sydney Opera House.I don't know its' offical name but set onto a plate or into an empty wine glass, this a very elegant addition to a classy table setting.

SERVIETTE/NAPKIN FOLDING, ELEGANT BASIC ROLL

Steps:

• Lay your serviette square out flat before you in the shape of the square.
• Fold the bottom left and right corners up to meet the top left and right corners so that you now have a rectangle shape with the crease at the bottom.
• Take the top and bottom right corners and roll them all the way to the left top and bottom corners.
• Slip the serviette ring over the rolled end and bring up to the half way point. Set the serviette on a plate with the join at the back and the closed neat part of the roll facing the top.