Chefs Spinach Salad Food

CHEF'S SPINACH SALAD

Steps:

• In a small bowl, combine the onion, vinegar and sugar; let stand for 15 minutes. On a serving platter, arrange the spinach, tomatoes, corn, ham, turkey and cheese. Drain onion mixture and place onions over salad. In a bowl, whisk the dressing ingredients. Serve with salad.

SPINACH SALAD WITH WARM BACON DRESSING

Steps:

• Remove the stems from the spinach and wash, drain and pat dry thoroughly. Place into a large mixing bowl and set aside.
• Place the eggs into an electric kettle and cover with cold water by at least 1-inch. Turn the kettle on. Once the water comes to a boil, the kettle will turn itself off. Leave the eggs in the water for 15 minutes. Remove and peel off the shell. Slice each egg into 8 pieces and set aside.
• While the eggs are cooking, fry the bacon and remove to a paper towel to drain, reserving 3 tablespoons of the rendered fat. Crumble the bacon and set aside.
• Transfer the fat to a small saucepan set over low heat and whisk in the red wine vinegar, sugar and Dijon mustard. Season with a small pinch each of kosher salt and black pepper.
• Add the mushrooms and the sliced onion to the spinach and toss. Add the dressing and bacon and toss to combine. Divide the spinach between 4 plates or bowls and evenly divide the egg among them. Season with pepper, as desired. Serve immediately.

SPINACH SALAD

Steps:

• Slice onions into thin circles, using all of the white and 1/2 of the green. Saute onions and bacon until the bacon is crispy and the onions are translucent, about 5 minutes.
• Add brown sugar and stir. When that is well blended into a lumpy sticky mess, add the beer. Let this reduce for about 5 minutes, or until it becomes thick and syrupy.
• Add a pinch of salt and several turns of fresh cracked pepper. Add balsamic vinegar and combine well.
• Combine the spinach, cucumber, bell pepper, and Gorgonzola in a bowl. Pour hot dressing over the salad, toss, and serve immediately.
• Measure out all grains using a scale. Run the grain through a mill to crack the husk and release the starch; a supplier can do this.
• In a 6 to 10 gallon boiling pot, with screen in bottom, also known as a false bottom, add the gypsum to 2 1/2 gallons of water preheated to 168 degrees F. Pour crushed grains and wheat into the water and stir until mixed thoroughly.
• Cover the pot and let stand for about one hour periodically checking the to be sure it stays between 146 to 152 degrees F.
• Have available another 6 to 10 gallon pot of water heated to 180 to 190 degrees F also on the stove, about 7 gallons worth.
• Remove grain pots' cover, sparging [spraying], and gently sprinkle the hot water over the grain mixture until you get 2 to 3 inches of water on top of the mixture. Then attach a flexible tube to the outflow of the grain pot (masher) and turn the spigot on. This opens a valve that allows drainage of the sweet liquid (wort) from the bottom. Keep a steady stream of hot water sprinkling over the mixture while allowing a third pot to be filled with the drainage (this takes about 20 minutes).
• Once you have collected about 6 1/2 gallons close the spigot and stop the sprinkling then place this pot on the stove. Bring to a boil (this takes about 25 to 30 minutes). Once brought to a boiling, start a timer, add the molasses, and boil for a total of 15 minutes without any hops.
• At 15 minutes add 2/3 ounce of Cascade hops; for bittering, continue to boil. After an additional 30 minutes add 1 ounce Fuggles hops; for flavor, continue to boil. After an additional 15 minutes add 1/2 ounce Cascade, 1/3 ounce Fuggles and 1/3 ounce Kent Goldings hops; also for flavor, continue to boil. Also add copper chilling coil to the boil at this time to sterilize it (standard home brewing equipment). After an additional 15 minutes add 1/2 ounce of Kent Goldings and 1/3 ounce of Fuggles hops; for aroma, and stir for a few seconds then switch off the heat.
• Remove the pot containing the wort to the sink, attach a plastic tube to the faucet and another to the outflow of the copper coil, and run cold water through the coil immersed in the wort. This will cool down the wort in about 20 minutes to fermentation temperature, approximately 75 degrees F. You could chill the wort by placing it in an ice bath but this would take much longer.
• Next, the wort is transferred into a sterilized fermenter. Shake the container to add air to the wort. Finally, the yeast is added to the fermenter, and an airlock is attached.
• Yield: 5 gallons
• The recipes for this program, which were provided by contributors and guests who may not be professional chefs, have not been tested in the Food Network's kitchens. Therefore, the Food Network cannot attest to the accuracy of any of the recipes.
• Measure out all grains using a scale. Run the grain through a mill to crack the husk and release the starch; a supplier can do this. In a 6 to 10 gallon boiling pot, with screen in bottom, also known as a false bottom, add the gypsum to 2 1/2 gallons of water preheated to 168 degrees F. Pour crushed grains and wheat into the water and stir until mixed thoroughly. Cover the pot and let stand for about one hour periodically checking the to be sure it stays between 146 to 152 degrees F.
• Have available another 6 to 10 gallon pot of water heated to 180 to 190 degrees F also on the stove, about 7 gallons worth.
• Remove grain pots' cover, sparging [spraying], and gently sprinkle the hot water over the grain mixture until you get 2 to 3 inches of water on top of the mixture. Then attach a flexible tube to the outflow of the grain pot (masher) and turn the spigot on. This opens a valve that allows drainage of the sweet liquid (wort) from the bottom. Keep a steady stream of hot water sprinkling over the mixture while allowing a third pot to be filled with the drainage (this takes about 20 minutes).
• Once you have collected about 6 1/2 gallons close the spigot and stop the sprinkling then place this pot on the stove. Bring to a boil (this takes about 25 to 30 minutes). Once brought to a boiling, start a timer, and boil for a total of 10 minutes without any hops.
• Add Willamette hops and 1/2 ounce Fuggles hops; for bittering, continue to boil. After an additional 45 minutes add remaining Fuggles hops for flavor, add the copper chilling coil to sterilize it and continue to boil.
• After an additional 14 minutes add Kent Goldings hops for aroma, stir, and immediately switch off the heat. Remove the pot containing the wort to the sink, attach one plastic tube to faucet and the copper inflow and another to the copper outflow, the other end runs into the sink, and turn on the cold water. Cool it down to fermentation temperature of 75-degrees F. This takes about 20 to 25 minutes.
• Next, the wort is transferred into a 5 gallon sterilized fermenter. Shake the container to add air to the wort. Finally the yeast is added to the fermenter and an airlock is attached. This fermenter is allowed to stand for 1 week prior to the addition of the raspberries.
• At the end of the week, take a large stockpot and add the raspberries and 1 to 2 quarts water. Bring ingredients to 140-degrees F. and allow to stay at this temperature for 30 minutes.
• Set aside and let cool. Once cooled, add this into a 6 gallon sanitized fermenter through a sterilized funnel. Siphon the beer from the previous week into the same fermenter once the raspberries have cooled. If you do not let it cool, you could kill the yeast. Attach airlock and allow it to ferment an additional week.
• At the end of the week siphon the beer off the raspberries into a third fermenter and allow to finish fermentation for 1 to 2 more weeks.
• Yield: 5 gallons

CLASSIC SPINACH SALAD

Steps:

• In a large bowl toss together the spinach, crumbled bacon, if using or eggs, mushrooms and red onion. Top with your favorite vinaigrette.

SESAME SEARED TUNA AND SUSHI BAR SPINACH SALAD

Steps:

• Place spinach in a dry pot set over medium-high heat and cook, stirring, until it just begins to wilt, 1 to 2 minutes. Transfer into a strainer to cool.
• While spinach cools, toast white sesame seeds in a dry pan over medium heat until light golden brown. Transfer into a mortar and pestle and crush into a very coarse paste, leaving some seeds whole. Add white sugar, soy sauce, and mirin. Stir with a wooden spoon to combine and reserve.
• Transfer cooled spinach to a towel and squeeze out any excess liquid. Chop roughly and add to a mixing bowl. Add the dressing and mix well. Cover and chill thoroughly before serving.
• Mix mayonnaise, miso paste, and rice vinegar together for miso mayo sauce. Place in the refrigerator until needed.
• Lightly salt tuna steaks, and then coat all sides well with as many sesame seeds as you like, pressing them lightly as you do.
• Brush a nonstick pan with oil and place over medium heat. Sear tuna steaks in the hot pan for 30 to 45 seconds on each side, as well as each edges.
• Slice and place tuna over the miso sauce. Brush tuna with ponzu and serve with spinach salad on the side.