Simple Fish And Tomato Curry Food

FISH CURRY | INDIAN FISH MASALA

Steps:

• Marinate fish with ½ tbsp ginger garlic paste, ⅛ tsp turmeric, ¼ tsp red chilli powder & ¼ tsp salt.
• On a flat fry pan, heat 1 tsp oil. Fry fish pieces slightly until the raw smell goes away just for 2 to 3 mins on both sides. You can also sear the fish. Keep this aside. (refer picture below)
• Heat 1 tbsp oil in a pot and add cumin. When they sputter, add onions and saute until lightly golden.
• Next add ginger garlic paste and saute for 30 seconds. Add tomatoes & ½ tsp salt. Saute until tomatoes turn soft and mushy.
• Next add coconut, fennel seeds (optional), red chili powder & turmeric. Fry until the mixture turns fragrant & raw smell has gone away.
• Cool this & add to a blender jar along with 2 to 4 tbsps water. Blend to a smooth or coarse paste to suit your liking. (refer notes). You can also use a immersion blender. Keep this aside.
• Add 1 tbsp more oil to the same pot used earlier. Heat up on a low flame.
• When the oil turns slightly hot, add curry leaves & green chilies.
• When they splutter, add the ground onion tomato paste and garam masala. Fry until the mixture smells good. If you feel it is not hot enough for your taste, then add more chilli powder at this stage & saute.
• Pour 1 ¼ to 1½ cup water. Mix and bring it to a boil. Cook until you see traces of oil on the surface and the gravy thickens a bit.
• Gently slide the fish pieces and cook covered on a medium heat.
• Carefully flip or turn the pieces to the other side after 3 to 4 mins.
• Cook until the fish pieces bulge a bit. This is the indication they are cooked completely. Taste the curry and add more salt if needed.
• Optionally garnish fish curry with coriander leaves if desired.

GOAN FISH CURRY

Steps:

• Place Curry Paste ingredients in a tall jug or milkshake container (something that fits the head of a blender stick) then blitz on high for 5 to 10 seconds until the onion is pureed. Add more water if needed to make it puree.
• Sizzle black mustard seeds: Heat oil over medium heat in a large pot. Add black mustard seeds and let them sizzle for 30 seconds - careful, they might pop!
• Saute onion: Add red onion and cook for 3 minutes until edges start to tinge with gold.
• Cook off curry paste: Add curry paste and cook for 3 minutes - to evaporate water, make spices bloom and cook garlic & ginger.
• Cook off tomato: Turn heat up to medium high. Add tomato paste and tomato pulp, cook for 2 minutes.
• Coconut milk: Add water, coconut milk, sugar, salt and chilli powder if using. Stir, then bring to simmer, low heat so it's bubbling gently.
• Simmer 2 minutes, add tomato & green chilli: Simmer for 2 minutes, add tomato and green chilli.
• Simmer 3 minutes: Simmer for another 3 minutes, stirring every now and then - sauce should be thickened (not watery), it gets looser again when fish is added (because fish will drop some juices = even more flavour!).
• Add fish: Add fish, stir, cook for 3 to 4 minutes until fish easily flakes.
• Garnish & serve: Remove from stove and transfer to serving bowl. Garnish with coriander/cilantro and fresh green chillies if desired. Serve with basmati rice!

FRIED FISH & TOMATO CURRY

Steps:

• Heat 2 tsp oil in a pan. Tip in the onions and a pinch of salt. Cook for about 8 mins until soft and golden.
• Meanwhile, blitz the tomatoes, garlic and ginger in a food processor to a smooth purée. Add the curry paste to the onions and fry for 3 mins more. Stir in the tomato mix and simmer for 10 mins until thickened. Add the coconut milk and chopped coriander. Simmer again to thicken.
• Dust the fish fillets in some seasoned flour. Heat the remaining oil in a non-stick frying pan. Cook the fillets, in batches, over a high heat for 1 min or so on each side, until they begin to brown. Carefully place fish in the tomato mixture and simmer until just cooked through. Scatter over coriander sprigs and serve with rice.

FISH AND TOMATO CURRY

Steps:

• Cut the fish into large pieces .
• Heat the oil in a saucepan and on low heat fry the onion, garlic and coriander stirring until the onion is soft.
• Add the Cumin, Turmeric and Chilli powder and stir for 1-2 minutes. Add the chopped tomato salt, Garam Masala and water.
• Simmer until the tomato is cooked to a pulp then add lemon juice.
• Place fish into the sauce and carefully simmer for about 3-4 minutes, taking care not to break the fish up.
• Serve with rice and accompaniments.

TOMATO & TAMARIND FISH CURRY

Steps:

• Blitz together the garlic, chilli, ginger, turmeric and ground coriander with 3 tbsp water. Heat the oil in a large pan and toast the cumin and fennel seeds, letting them sizzle until aromatic. Add the ginger paste and fry for 3 mins.
• Empty the tomatoes into the spice pan, plus a can of water. Add the beans, bring to the boil, then turn down the heat and simmer for 5 mins. Stir in the tamarind paste. Add the fish fillets, generously season with ground black pepper, cover and simmer for 10 mins. Take off the lid, carefully turn the fillets, then bubble the sauce until the fish is cooked through and the sauce is thick. Sprinkle over the coriander leaves and serve with rice.

FISH AND TOMATO CURRY

Steps:

• Spice Mixture:.
• Heat the oil in a wok or skillet over medium heat. Stir-fry the spice mixture ingredients until fragrant (1 to 2 minutes).
• Add the tomatoes with their juice, salt and sugar. Reduce heat to low, cover and cook for 5 minutes. Add the fish, cover and cook a further 5 minutes or until the fish is JUST cooked.
• Remove from the heat, divide into serving bowls and sprinkle with the fresh coriander. Serve with rice and the lemon wedges.

SUPER-QUICK FISH CURRY

Steps:

• Heat the oil in a deep pan and gently fry the onion and garlic for about 5 mins until soft. Add the curry paste and stir-fry for 1-2 mins, then tip in the tomatoes and stock.
• Bring to a simmer, then add the fish. Gently cook for 4-5 mins until the fish flakes easily. Serve immediately with rice or naan