Smoked Ribs On The Grill Food

PELLET-GRILL SMOKED RIBS

Steps:

• Preheat a pellet grill to 275 degrees F (see Cook's Note). Combine 2 tablespoons salt, 4 tablespoons coarsely ground pepper and 2 teaspoons paprika in a small bowl. Rub each rack of ribs all over with 1 tablespoon oil and sprinkle evenly with the salt and spice mixture on both sides.
• Transfer the ribs, meat-side up, to the grill grates. Cover the grill and cook for 1 hour.
• Meanwhile, combine 1/3 cup cider vinegar with 1/3 cup water in a spray bottle. After 1 hour spray the ribs with the vinegar-water mixture so they are damp all over. Cover and cook for 1 more hour.
• Meanwhile, combine the ketchup, 3/4 cup water, the remaining 1/3 cup cider vinegar, white vinegar, brown sugar, Worcestershire sauce, 2 teaspoons salt, 2 teaspoons pepper, hot sauce and the remaining 2 teaspoons paprika in a medium saucepan. Cook over medium heat until the mixture is warmed through and the sugar is melted, about 2 minutes. Set aside.
• Check the ribs and spray them again with vinegar-water. They should be starting to take on a red color from the smoke. Cover and cook until they are deep red, 30 to 45 minutes. Spray the ribs once more, then brush the meaty part of each rack with 1/4 cup of the sauce. Close the grill and cook for another 15 minutes so the sauce can set.
• Lay down two pieces of heavy-duty foil that are long enough to enclose each rack on a work surface and spread half of each sheet with 1/4 cup sauce. Transfer the rib racks, meat side down, onto the saucy part of the foil. Coat the bone sides with 1/4 cup sauce and a few sprays of the vinegar-water, then fold the foil over and seal tightly.
• Add another layer of foil if the first has punctured during wrapping. Transfer the ribs to a rimmed baking sheet and place on the grill (the baking sheet will catch any juices that leak out). Cover and cook until tender but not falling off the bone, about 2 hours.
• Remove from the grill and let rest 5 minutes before carefully unwrapping (watch out for hot steam). Slice each rack into individual rib portions and serve with the remaining sauce.

MEATHEAD'S LAST MEAL RIBS RECIPE

Steps:

• Prep. Rinse the ribs in cool water to remove any bone bits from the butchering.
• If the butcher has not removed the membrane from the under side, do it yourself. It gets leathery and hard to chew, it keeps fat in, and it keeps sauce out. To remove it, insert a butter knife under the membrane, then your fingers, work a section loose, grip it with a paper towel, and peel it off. If you can't get the skin off, with a sharp knife, cut slashes through it every inch so some of the fat will render out during the cooking. Click here to see more photos of how to skin 'n' trim ribs and here's a quickie 1 minute video of the technique.
• Trim the excess fat from both sides of the rack of ribs.
• Next it is time to add the salt. The rule of thumb is 1/2 teaspoon of kosher salt per pound of meat, but ribs are about 50% bone, so use about 1/4 teaspoon per pound. You can simply eyeball it by sprinkling on the same amount of salt you would sprinkle on the ribs if they were served to you unsalted. If you can, give the salt 1 to 2 hours to be absorbed. The process of salting in advance is called dry brining.
• Before adding a BBQ rub, be aware of double salt jeopardy! Rubs and spice blends are a great way to add flavor to meat, but almost all commercial rubs contain salt so be careful not to pre-salt the ribs if you plan on using one of these rubs otherwise they will be unbearably salty. Also note that some ribs sold in grocery stores are labeled as "enhanced" or "flavor enhanced" or "self-basting" or "basted," meaning that they have been injected with a brine at the packing plant so if you are using these you probably want to use a rub that doesn't include salt like our Meathead's Memphis Dust recipe.Some folks insist on putting the barbecue rub on the night before, but it isn't necessary. The molecules in spices are too large to penetrate more than a tiny fraction of an inch. Read this for the science.
• Before applying the rub, just coat the meat with a thin layer of water. The water helps dissolve the spices. A lot of cooks like to use mustard under the rub as a form of glue. Mustard is water, vinegar, and maybe white wine (all mostly water) with mustard powder mixed in. The amount of mustard powder is so small that by the time the water steams off and drips away, the mustard powder remaining is miniscule. My experience is that using a mustard slather makes little or no difference in the final outcome. If you want a mustard flavor, you will do much better by simply sprinkling it on the meat. Once wet, sprinkle enough Meathead's Memphis Dust to coat all surfaces but not so much that the meat doesn't show through. That is about 2 tablespoons per side depending on the size of the slab. Spread the Memphis Dust on the meat and rub it in.
• Fire up. Pre-heat your barbecue smoker or set up your grill for 2-zone (indirect) cooking. Adjust the dampers on your cooker to bring the temperature to about 225°F and try to keep it there throughout the cook. Cooking at 225°F will allow the meat to roast low and slow, liquefying the collagen in connective tissues and melting fats without getting the proteins knotted in a bunch. It's a magic temp that creates silky texture, adds moisture, and keeps the meat tender. If you can't hit 225°F, get as close as you can. Don't go under 200°F and try not to go over 250°F.When monitoring the cooker temperature you can absolutely positively noway nohow rely on bi-metal dial thermometers. If you are not monitoring your cooker with a good digital oven thermometer, you are setting yourself up for disappointment. Using a dial thermometer is like trying to send email with a typewriter. Click here to read my buyer's guide to thermometers.Once you have reached the desired temperature, add about 4 ounces of dry wood, placing it as close to the flame as possible.
• Cook. Put the slabs in the cooker in indirect heat, meaty side up, close the lid, go drink a beer, read a book, or make love.
• When the smoke dwindles after 20 to 30 minutes, add another 4 ounces of wood. After that, DO NOT add any more wood. On your first attempt, resist the temptation. Nothing will ruin a meal faster and waste money better than over-smoked meat. You can always add more the next time you cook, but you cannot take it away if you over-smoke.
• If you have more than one slab on, halfway through the cook you will need to move the ribs closest to the fire away from the heat, and the slabs farthest from the flame in closer. Leave the meat side up. There is no need to flip the slabs. You can peek if you must, but don't leave the lid open for long.
• This next step is known as the Texas Crutch. This optional trick involves wrapping the slab in foil with about an ounce of water for up to an hour to speed cooking and tenderize a bit. Almost all barbecue ribs competition cooks use the Texas Crutch to get an edge. But the improvement is really slight and I never bother for backyard cooking. If you crutch too long you can turn the meat to mush and time in foil can soften the bark and remove a lot of rub. I recommend it only for barbecue competitions when the tiniest improvement can mean thousands of dollars. Skip it and you'll still have killer ribs. But if you've seen it on TV and must try it, click here to learn more about The Texas Crutch. The Texas Crutch is it is baked into a popular technique called the 3-2-1 method which I do not recommend. Two hours in foil or butcher paper is far too long and can make the meat mushy. Try the Texas Crutch after you master the basics.
• For cooking time, allow 5 to 7 hours for St. Louis Cut (SLC) Ribs or Spare Ribs, and 3 to 5 hours for Baby Back Ribs. Thicker, meatier slabs take longer. If you use rib holders so they are crammed close to each other, add another hour.
• When it is time to find out whether or not the ribs are ready, we us the bend test (a.k.a. the bounce test). Although we insist that you buy a good digital meat thermometer for most smoking and grilling, this is one of the few meats on which you cannot use a meat thermometer because the bones have an impact on the meat temp and because the meat is so thin. To conduct the bend test, pick up the slab with tongs and bounce it gently. If the surface cracks as in the picture above, it is ready. Here are some other tricks to tell when ribs are ready.
• Once the ribs are done cooking it is time to add the sauce unless you intend to serve them "dry" like they do in Memphis. The key to saucing ribs is to go easy on it so that the meat can shine through. Simply paint both sides of the rack with your favorite home made barbecue sauce or store-bought barbecue sauce and cook for another 15 minutes or so. Don't put the sauce on earlier than that. It has sugar and there is a risk it can burn. Now here's a trick I like: Sizzle on the sauce. Put the ribs with sauce directly over the hottest part of a grill in order to caramelize and crisp the sauce. On a charcoal grill, just move the slab over the coals. On a gas grill, crank up all the burners. On a water smoker, remove the water pan and move the meat close to the coals. On an offset smoker, put a grate over the coals in the firebox and put the meat there. With the lid open so you don't roast the meat from above, sizzle the sauce on one side and then the other. The sauce will actually sizzle and bubble. Stand by your grill and watch because sweet sauce can go from caramelized to carbonized in less than a minute! One coat of a thick sauce should be enough, but if you need two, go ahead, but don't hide all the fabulous flavors under too much sauce. If you think you'll want more sauce, put some in a bowl on the table.
• Serve. Once sauced, slice the rack between the bones. If you've done all this right, you will notice that there is a thin pink layer beneath the surface of the meat. This does not mean it is undercooked! It is the highly prized smoke ring caused by the combustion gases and the smoke. It is a sign of Amazing Ribs. Now plate, serve to your guests, and take a bow when the applause swells from the audience.

BBQ RIBS ON THE GRILL

Steps:

• Preheat grill for low heat.
• Cut ribs in half and season with steak seasoning. Place ribs, bone-side down, in a foil pan; add water. Cover pan with a sheet of aluminum foil.
• Cook ribs on the preheated grill, adding water every hour if liquid has evaporated, 1 1/2 to 2 1/2 hours. Add barbeque sauce to ribs and continue cooking for 30 minutes more. An instant-read thermometer inserted into the center should read 145 degrees F (63 degrees C).

SMOKED RIBS ON THE GRILL

Steps:

• Combine marinade ingredients and pour over ribs in a non-reactive dish, cover and place in the refrigerator for three hours or over night.
• Wood chips for smoke, oak, hickory, cherry, apple or mesquite, about three cups, soak in water for at least one hour.
• Make three pouches of soaked chips in tin foil, poke small holes with a fork into both sides of pouches, place one pouch on one side of grill with grate removed and heat on high until smoke starts, place ribs on grill over unlit side, lower heat to about 300 degrees, close lid. Allow ribs to smoke for 3 hours changing smoke pouch each hour.
• After 3 hours of cooking, check to see if any racks are ready to come off the grill. They are done when the meat has shrunk back from most of the bones by 1/4 inch or more. When you lift a rack by picking it up from one end with tongs, the rack should bend in the middle and the meat should tear easily. If the meat does not tear easily, continue to cook the ribs. The total cooking time could be anywhere from 3 to 4 1/2 hours.
• Remove and tent loosely with foil. Allow ribs to rest for 10 minutes.
• Ribs can also be cooked in smoker at 225 degrees for about 4-6 hours.

BEST BARBECUE RIBS EVER

Steps:

• Combine the brown sugar, chili powder, 1 tablespoon salt, 1 teaspoon black pepper, the oregano, cayenne, garlic powder and onion powder in a small bowl and rub the mixture on both sides of the ribs. Cover and refrigerate 1 hour or overnight.
• Preheat the oven to 250 degrees F. In a roasting pan, combine the broth and vinegar. Add the ribs to the pan. Cover with foil and tightly seal. Bake 2 hours. Remove the ribs from the pan and place them on a platter. Pour the liquid from the pan into a saucepan and bring to a boil. Lower the heat to a simmer and cook until reduced by half. Add the barbecue sauce.
• Preheat an outdoor grill to medium high. Put the ribs on the grill and cook about 5 minutes on each side, until browned and slightly charred. Cut the ribs between the bones and toss them in a large bowl with the sauce. Serve hot.

BOILED THEN GRILLED BBQ RIBS

Steps:

• 1. Cut ribs into quarter racks and trim all silver fat off.
• 2. Combine in large pan. Water, salt, pepper, garlic, and sliced onion.
• 3. Bring water to a boil.
• 4. Rinse ribs and add to boiling water.
• 5. Reduce heat to simmer after ribs are in and simmer for 45 minutes approximately.
• 6. After 45 minutes make sure the ribs are ready to be grilled.
• 7. Sauce the ribs generously leaving extra sauce for during grilling.
• 8. Throw ribs on the hot ready grill until they are cooked all the way thru.
• 9. Use foil to cook slow if needed.
• 10. Sauce as the ribs cook until they are done flipping them frequently.
• 11. Enjoy!