Ginger Biscuits Mary Berry Food

MARY BERRY'S GINGER OAT CRUNCH BISCUITS

Steps:

• Preheat the oven to 180˚C/160˚C Fan/Gas 4, then line 3-4 baking sheets with baking paper (see note) or line two sheets and cook in batches. Measure the butter, golden syrup and sugar into a saucepan and warm through over a medium heat until runny. Remove from the heat and add the flour, semolina, oats and ginger. Stir until well incorporated, then tip on to a baking sheet, flatten out and leave to cool for 10 minutes. Scoop up teaspoonfuls of the mixture (which will be quite crumbly and buttery) and roll into 36 little balls, then place on the prepared baking sheets, well spaced apart. Push down slightly to flatten and then bake in the oven for about 15 minutes until lightly golden. Leave to cool on the baking sheets, then store in an airtight container when completely cold. Cook's Notes: • The butter can be used straight from the fridge or at room temperature - it does not matter as it's being melted. • Coat your spoon in a little oil before measuring the syrup - it will slip off easily and give a more accurate measurement. • Silicone baking mats are a great alternative to baking paper - the biscuits slide off easily and the mats can be washed and used again. Prepare Ahead: These can be made ahead and stored in an airtight container for up to 3 days. Freeze: Freeze the cooked biscuits for up to 3 months. The uncooked dough balls also freeze well.

GINGER BISCUITS

Steps:

• Heat the oven to 190C/170C fan/gas 5. Line two large baking trays with baking parchment. In a saucepan over a low heat, melt the butter, sugar, fresh ginger and golden syrup and leave to cool.
• Mix the flour, ground ginger and bicarbonate of soda together in a bowl with a wooden spoon. Gradually stir in the cooled sugar mixture and the egg yolk and knead briefly to make a dough.
• Roll the dough into 20g balls and put on the prepared baking trays with 3cm between each to allow for spreading. Bake for 8-10 mins until golden brown. Leave to cool on the trays for a min, then transfer to a cooling rack to cool completely.