Chocolate Crunch Bark Recipe By Tasty Food

EASY CHOCOLATE BARK

Steps:

• If you have time, toast the nuts/seeds: Preheat the oven to 350 degrees Fahrenheit. Toast the nuts/seeds on a rimmed baking sheet until fragrant and turning lightly golden on the edges, about 6 to 9 minutes. Transfer the nuts to a cutting board and roughly chop them.
• In the meantime, melt the chocolate in a microwave-safe bowl in 30-second increments, stirring after each one. Don't overdo it. The chocolate is done when it's about 90% melted-keep stirring off the heat and the pieces should completely dissolve. (Alternately, you can use melt it in a heat-proof bowl set over a saucepan of gently simmering water.)
• Cover a large, rimmed baking sheet with parchment paper. Use a silicone or rubber spatula to spread chocolate evenly over the center area of the baking sheet-aim for about 1/4″ thickness (it won't reach the edges).
• Sprinkle the nuts evenly over the chocolate, followed by the dried fruit. If you're adding flaky salt, crush it between your fingers as you sprinkle it over the chocolate. Lightly use your palms to press the toppings into the chocolate.
• If you're in a hurry, place the pan on a flat surface in the refrigerator to harden for about 15 minutes. If you're not, let the chocolate cool at room temperature for 2 to 4 hours, until completely hardened.
• Once the chocolate is completely hardened, use your hands to break it into about 25 pieces. Serve immediately, or cover and store at room temperature for up to 1 week.

JEWELED CHOCOLATE BARK CRUNCH

Steps:

• Throw the chocolate and coconut oil into a heat-resistant bowl and set over a pan of simmering water. Let them melt, about 3 minutes. Give them a stir, then add the bashed sea salted pretzels and 1.5 ounces of the chopped toasted hazelnuts and give it another stir.
• Pour the chocolatey goodness onto a baking sheet lined with parchment paper. Spread the mixture out as thin as possible, scatter over the snapped pretzels, pistachios, freeze-dried strawberries and remaining 0.5 ounce hazelnuts.
• Then all you have to do is chill it in the refrigerator for 20 minutes.
• Chop the bark into shards and serve on a platter.

CRUNCHY CHOCOLATE MATZO BARK

Steps:

• Preheat the oven to 350 degrees F. Arrange 2 oven racks in the center of the oven.
• Cover 2 baking sheets with a tight layer of aluminum foil, then place an additional sheet of foil on top. Spray the foil with nonstick spray as a precaution. Spread 2 pieces of matzo in a single layer on each of the baking sheets.
• In a medium heavy-bottomed saucepan, heat the butter and brown sugar over medium heat, stirring, until the butter melts and the sugar dissolves and becomes smooth, 3 to 5 minutes. Bring the mixture to a boil, then shut off the heat.
• Use a large spoon to spread the brown sugar mixture over the matzo, coating the tops of all the squares. Bake until the sugar bubbles and browns, 10 to 12 minutes. Remove from the oven.
• In a double boiler or microwave, gently melt the chocolate. Let the matzo cool 10 minutes, then use a rubber spatula to gently spread the melted chocolate over the brown sugar layer.
• While the chocolate is still warm, sprinkle evenly with the pumpkin seeds, apricots, sprinkles and salt, if using. Cool in the refrigerator for 15 to 20 minutes to allow the chocolate to harden.
• Use a serrated knife to "saw" the bark into neat squares or break the matzo into pieces. I like to serve this treat from a cookie tin or a little basket to make it even more fun to eat.

CHOCOLATE CRUNCH

Steps:

• Heat the oven to 180C/160C fan/gas 4. Butter a 20cm square tin and line with baking parchment. Stir the melted butter and vanilla together in a bowl. Mix the caster sugar, flour and cocoa together in another bowl.
• Pour the bowl of wet ingredients into the dry and beat together, then add the egg and beat again until combined. Press into the prepared tin. Brush the top with water and sprinkle over the granulated sugar.
• Bake for 30-35 mins. Leave to cool slightly in the tin for 5 mins before slicing into squares and transferring to a wire rack to cool completely.