Simple Caffe Latte Cafe Quality At Home Food

CAFE LATTE

Steps:

• Heat milk in a saucepan set over medium-low heat. Whisk briskly with a wire whisk to create foam. Brew espresso and pour into 4 cups. Pour in milk, holding back the foam with a spoon. Spoon foam over the top.

SIMPLE CAFFE LATTE (CAFE QUALITY AT HOME!)

Steps:

• Pour cold milk into a saucepan and heat on medium heat just until too hot to put your finger into it.
• Pour espresso into 2 mugs.
• Pour the steamed milk into mugs over the brewed espresso.
• Enjoy!

CAFE LATTE'S TURTLE CAKE

Steps:

• Preheat the oven to 350 degrees F. Grease 3 (9-inch) cake pans.
• Cover the bottom of each pan with parchment paper, cut to size.
• In a medium bowl, combine the egg, oil, and buttermilk. In another larger bowl, stir together the flour, sugar, cocoa, baking soda, and salt. Gradually add the wet ingredients to the dry ingredients until well mixed. Gradually add the hot coffee, and stir again to combine. Scrape the batter into the prepared pans. Bake the cakes for 25 to 30 minutes, or until a toothpick inserted in the center comes out clean. Let the cakes rest in the pans for 10 minutes, and then turn out onto wire racks to cool completely.
• Combine the milk and sugar together in a medium saucepan. Add the butter, and then bring to a boil over medium-high heat, stirring frequently. Remove pan from heat. Add chocolate chips to the pan and, using a wire whisk, mix until smooth. (Note: If frosting is too thick, add 1 or 2 tablespoons hot coffee.)
• Place 1 cooled cake layer with the top side down on a cake plate. Spread with 1/3 of the frosting, pushing it out slightly from the edges to make a ripple or petal effect. Sprinkle frosting with 1/2 cup toasted pecans and drizzle with 1/4 cup caramel. Add the next layer, again with the top side down. Repeat frosting layers. Place the top layer with the top side up. Repeat frosting layers.

GRANDE CAFFE LATTE

Steps:

• First, pour both espresso shots into the bottom of a cup. Add steamed milk until cup is 3/4 full, holding back the foam. Top off the drink with velvet foam from steamed milk.

HOW TO MAKE A CAFE LATTE

Steps:

• Gather the ingredients.
• Place the water into the boiler of your espresso machine.
• Put the coffee into the portafilter.
• Tamp (press) the coffee down using a tamper. Do this 2 to 3 times to make sure the grounds are packed tightly.
• Place the portafilter into your espresso machine's group head and lock it in place by turning it to the right.
• Place a latte cup (or the glass carafe that came with your espresso machine) under the group head and pull the shot for 25 to 30 seconds. (Typically, there is a lever, switch, or button to start this process.)
• Once the shot is pulled , add the flavored syrup, if using.
• Place the milk into either a glass measuring cup or a small metal pitcher.
• Insert the steam wand into the container with the milk, just under the surface.
• Engage the steam wand on your espresso machine. (You may need to read your espresso machine's manual for this, as each espresso maker is a little different.)
• Make sure to keep the tip of the wand toward the side of the container. This will create a vortex with the milk.
• Move the container higher, lower, closer, then further so that the steam wand can incorporate the air into the milk, making the foam. The bubbles should get smaller and smaller as you do this.
• Once the milk has foamed to double its size, turn off the steam wand.
• Use a spoon to retain the microbubbles on top of the steamed milk and pour the bottom 2/3 of the steamed milk into the latte cup.
• Top the latte with the remaining bubbles by pouring or spooning them onto the drink.
• Serve and enjoy.

CAFFE LATTE

Steps:

• Using the steam attachment on an espresso machine, warm and froth milk. Divide espresso between 2 coffee cups. Pour 1 cup of the warmed milk from beneath the froth into each cup. Spoon milk foam on top and serve.

LATTE

Steps:

• Make around 35ml espresso using your coffee machine and pour it into the base of your cup.
• Steam the milk with the steamer attachment so that it has around 2-3cm of foam on top. Hold the jug so that the spout is about 3-4cm above the cup and pour the milk in steadily. As the volume within the cup increases, bring the jug as close to the surface of the drink as possible whilst aiming to pour into the centre. Once the milk jug is almost touching the surface of the coffee, tilt to speed up the rate of pour. As you accelerate, the milk will hit the back of the cup and start naturally folding in on itself to create a pattern on the top.