Pineapple Ribs Food

PINEAPPLE STICKY RIBS

Steps:

• Preheat oven to 350 degrees F (175 degrees C). Arrange ribs in a single layer in a roasting pan.
• Stir pineapple, jam, soy sauce, vinegar, brown sugar, garlic, ginger, salt, black pepper, and cayenne pepper together in a bowl; pour over ribs.
• Bake in the preheated oven, basting every 15 minutes, until ribs are glazed and pull away easily from the bone, about 1 1/2 hours. An instant-read thermometer inserted into the center should read 145 degrees F (63 degrees C).

PINEAPPLE GLAZED PORK RIBS

Steps:

• Preheat the oven to 300 degrees F.
• Rub the ribs all over with the sesame oil; season generously with five-spice powder, salt, and pepper. Arrange the ribs in a single layer in a shallow roasting pan and roast for 2 to 2 1/2 hours.
• To prepare the pineapple glaze: In a saucepan over medium heat melt the butter and add the pineapple chunks; saute for 3 minutes. Add the soy sauce, rum, hoisin sauce, ketchup, vinegar, brown sugar, chile, garlic, and ginger. Bring to a slow simmer and cook, stirring, until thickened, about 20 minutes. Pull out the ginger pieces. Pour the glaze into a blender and puree until smooth.
• In the last 30 minutes of cooking, baste the ribs with some of the glaze. When they are done, the pork will pull away from the bone and you will see about 1/2-inch of bone showing. When you are ready to eat, baste the ribs with more glaze and stick them under the broiler for 5 to 8 minutes to give the ribs a nice crust. (Watch them carefully as they can easily burn.) Separate the ribs with a cleaver or sharp knife, pile them onto a platter, and pour on the remaining sauce. Sprinkle with sesame seeds and chopped cilantro before serving.

STICKY PINEAPPLE RIBS

Steps:

• Separate pork into ribs.
• Put in greased 9x13 pan.
• Combine remaining ingredients and pour over ribs, turning to coat.
• Bake 350 degrees for 1 1/2 hours or till glazed and tender.
• Baste every 15 minutes without turning.
• Serve sauce over ribs.

SWINEAPPLE

Steps:

• Prepare a grill for medium indirect heat: For a gas grill (with 3 or more burners), turn all the burners to medium-high heat; after about 15 minutes turn off one of the middle burners and turn the remaining burners down to medium. For a charcoal grill, bank one chimney starter-full of lit and ashed-over charcoal briquettes to one side of the grill. Set up a drip pan on the other side to avoid flare-ups. (Be sure to consult the grill manufacturer's guide for best results.)
• Slice off the top and bottom of the pineapple with a sharp knife and set the pieces aside. Remove the peel from the pineapple, cutting it off in strips. Using a paring knife, carefully hollow out the pineapple to a 3/4-inch-thick shell.
• Stuff the pineapple with the ribs. Place the top and bottom pieces back on the pineapple and secure them in place with 4 long bamboo skewers.
• Place a large piece of parchment on your work surface. Arrange 6 slices bacon horizontally on the parchment. The edges of the slices should touch but not overlap. Working with the remaining 6 slices, weave the bacon in an over-under pattern by lifting alternating slices of the horizontal bacon and vertically placing a slice of bacon over or under as needed to create a woven lattice design. Wrap the bacon lattice around the pineapple and secure it in place with 8 long bamboo skewers. Trim the protruding skewer tips down to 1/2 inch lengths with kitchen shears.
• Put the swineapple on the grill over the drip pan with the bacon seam-side down. Cover the grill and cook until the bacon is crispy and golden brown and the meat is hot in the center, about 1 hour. Transfer to a cutting board. Remove the skewers and slice the pineapple into rings for serving.

PINEAPPLE RIBS

Steps:

• Marinade:
• Combine the honey, sugar, soy, ginger, garlic, chilies and chipotle paste (if used)
• Place in a microwaveable container and heat for 60 seconds (800w microwave)
• Split the ribs (if not already done) and coat them in the sticky sauce. Place in a large, ovenproof dish, if possible leave a space between each rib. Tip the pineapple chunks on top and add the juice from the can, then add more pineapple juice until the ribs are at least halfway submerged - the amount required will depend on the size of your ribs and pan.
• Leave to marinade in a refrigerator for at least 4 hours, ideally 24 hours, and turn once or twice in the time you have.
• Pre-heat oven to 160C.
• Drain the marinade off the ribs and reserve - as this has been in contact with raw pork, it is not safe until cooked.
• Make sure the ribs are spaced evenly and cook for 90 minutes, covered with foil. Turn once about two thirds of the way through the cooking process.
• After 90 minutes, remove the foil and increase the oven temperature to 220C. Turn the ribs at the same time. Cook for a further 20/30 minutes. If you have time, once the ribs have blackened on one side, turn the ribs again.
• In the meantime, take the reserved marinade and put it in a saucepan (ideally a wide, non-stick one) over a medium heat. Stir vigourously on the heat until the sauce thickens. It should get sticky but no thicker than warm runny honey. If in doubt, add more pineapple juice and use a thinner sauce.
• To serve, place the ribs on white rice and drizzle the sauce liberally over them.

PINEAPPLE PORK RIBS

Steps:

• Lay each rack on a chopping board upside down. Using a very sharp paring knife, carefully remove the membrane that runs underneath. Using a tea towel, hold one corner of the ribs firmly, and pull the membrane sheet off in one long strip (hopefully!).
• Place the rib racks in a large non-metallic dish - you may need to split them into two dishes.
• Whisk all marinade ingredients together and when the marinade is completely cool, pour over the pork ribs.
• Cover the ribs tightly in cling film and let marinate for a minimum of 4 hours or overnight.
• If using a charcoal barbecue, organize it for indirect grilling - two small piles of hot charcoal on either side of the barbecue with a drip pan made from aluminum foil in the centre.
• If you are using a gas grill, set the grill on medium heat.
• Place the ribs in the middle of the barbecue, away from direct heat.
• Close the lid of the barbecue and leave the vents open for 1 ½ hours. Turn the ribs after 40 minutes. Baste them every 20 minutes with the remaining marinade.
• The ribs are ready when the meat has shrunk back away from the end of the bones. Slice between the bones and serve slathered in extra barbecue sauce.

SLOW-COOKER PINEAPPLE BABY BACK RIBS RECIPE BY TASTY

Steps:

• In a small bowl, combine the salt, pepper, onion powder, cayenne, cumin, chili powder, and garlic powder.
• Rub the spice mix all over the baby back ribs.
• Drain the juice from the can of pineapple and add to the slow cooker, along with the barbecue sauce. Stir to combine.
• Add the diced pineapple and ribs to the slow cooker and cover with the sauce.
• Cover and cook on high for 4 hours. Halfway through, flip the racks of ribs so the one that was previously on the bottom is now on top. Cover with more sauce.
• Remove the ribs from the slow cooker and cut into individual pieces. Serve with the leftover sauce and pineapple chunks.
• Enjoy!

FREAK'N GOOD RIBS

Steps:

• In a large baking dish, mix together the pineapple juice, brown sugar, mustard powder, ketchup, red wine vinegar, lemon juice, and soy sauce. Season with cloves, ginger, garlic, and cayenne pepper. Cut ribs into serving size pieces, and place into the marinade. Cover, and refrigerate, turning occasionally, for 8 hours or overnight.
• Preheat oven to 275 degrees F (80 degrees C). Cook ribs in marinade for 1 1/2 hours, turning occasionally to ensure even cooking.
• Preheat grill for medium heat.
• Lightly oil grate. Grill ribs for 15 to 20 minutes, basting with barbecue sauce, and turning frequently until nicely glazed.