Canning Sockeye Salmon How To Avoid Zombie Acopoly Food

CANNING SOCKEYE SALMON HOW TO AVOID ZOMBIE ACOPOLY

Steps:

• 1. Rinse the salmon in a salt water bath to help remove slime. Rinse under cold water and drain on paper towels.
• 2. Heat water in pressure canner to boiling. Boil jars for at least 5 minutes...remove to drain and dry
• 3. Heat a saucepan big enough to sanitize and heat the lids and rims. Drop in the lids to sanitize and soften the seals. IMPORTANT NOTE: NEVER reuse a lid. Lids are compromised once they have been opened. Always use brand new lids. (bands can be reused)
• 4. Add 1/2 tsp of salt to each sanitized jar. Pack jars with salmon---Skins facing the outside of the jar. Only pack to 1/2" of the top of the jar. Do not add any liquid.
• 5. Use a clean, wet paper towel to make sure the rim of each jar is clean and free of any debris.
• 6. Remove a lid (use a magnet lifter) from the hot water and wipe off any liquid. Place it on the jar and seal around lightly with your finger. Screw on the jar band but not overly tight.
• 7. Once all jars have lids and bands, place in the Canning Processor.
• 8. Attach the lid securely. Allow steam to escape approx 3 minutes. Then attach the pepcock.
• 9. When the temperature reaches 11 psi, turn down the heat to 4 or 5 medium low. and set the timer to 1 hour and 30 minutes. Watch the temp gauge closely. Do not let it go below 11 psi or start the timing all over again. It is safe to keep it between 11 and 15 psi.
• 10. After time is up, turn off the heat and allow the canner to come to rest. The pressure release valve will go back down.
• 11. IMPORTANT: When you lift the lid off the canner, lift the lid away from you. This will prevent scalding/burning yourself and fogging your glasses.
• 12. You might hear the jars sealing themselves before you even lift them out of the canner that is ok. Transfer the hot jars to a dry clean surface. (I like to use a bath towel)