Texas Dry Rub Beer Can Chicken Food

SPICE RUBBED BEER CAN CHICKEN

Steps:

• Heat a gas or charcoal grill with a lid big enough to accommodate the bird. Put a drip pan below the grates.
• Mix the ingredients for the Spice Rub until they are well blended. (This will keep, covered, in the refrigerator for 1 week.) Rub it all over the chicken, inside and out.
• Open the beer and take a big swig or just pour out a couple of ounces. Sit the chicken on the beer can so the legs are at the bottom and the wings are at the top. Stand the beer can on the grates over the drip pan. Put the cover on and cook over indirect heat until the juices run clear, about 1 hour. (If using charcoal, push the coals to 1 side so the chicken is not over direct heat.)
• Note: This chicken can also be cooked in a 350 degrees F oven. Just stand the beer can in a shallow roasting pan and cook about 1 hour or until juices run clear.

TEXAS DRY RUB BEER CAN CHICKEN

Steps:

• In a small bowl combine the rub ingredients.
• Remove and discard the neck, giblets, and any excess fat from the chicken. Rinse the chicken, inside and out, under cold water and pat dry with paper towels. Lightly spray or brush all over with the vegetable oil and season, inside and out, with the rub. Let rest at room temperature while you preheat your grill.
• Open the beer can an pour off half of the beer. (Or drink it if you don't want to waste it.) Set the half-full can of beer in can holder (or if you don't have a can holder, just be extra careful and place the can on a flat smooth surface), and add fresh rosemary leaves, minced shallot and lemon juice. This will help add moisture and flavor from the inside as your chicken cooks. You may need to use a funnel, to help add the ingredients to the can.
• Slide the chicken over the top so the can fits inside the cavity. Transfer the bird to your preheated grill, while carefully keeping the can upright. Carefully balance the bird on its two legs and the can holder. (If can holder is not used just use the can and use the legs like a tripod.) Grill over Indirect Medium heat until the juices run clear and the internal temperature reaches 170 F in the breast and 180 F in the thickest part of the thigh. 1 - 1/4 to 1 - 1/2 hours. Wearing barbecue mitts, carefully remove the chicken and the can (holder) from the grill. Do not spill the beer, it will be HOT. Let the chicken rest for about 10 minutes before lifting it from the can (holder). Discard the beer. Cut the chicken into serving pieces. Serve warm.
• ENJOY!

BEER CAN CHICKEN

Steps:

• If making the rub:
• Combine all the ingredients in a jar, twist the lid on airtight, and shake to mix. Store away from heat or light for up to six months. Makes about 1/2 cup. Enough for 4 to 6 racks of ribs.
• Remove and discard the fat just inside the body cavities of the chicken. Remove the package of giblets, and set aside for another use. Rinse the chicken, inside and out, under cold running water, then drain and blot dry, inside and out, with paper towels. Sprinkle 1 tablespoon of the rub inside the body and neck cavities, the rub another 1 tablespoon all over the skin of the bird. If you wish, rub another 1/2 tablespoon of the mixture between the flesh and the skin. Cover and refrigerate the chicken while you preheat the grill.
• Set up the grill for indirect grilling (see below) placing a drip pan in the center. If using a charcoal grill, preheat it to medium.
• If using a gas grill, place all the wood chips in the smoker box and preheat the grill to high; then, when smoke appears, lower the heat to medium.
• Pop the tab on the beer can. Using a "church key" style can opener, make 6 or 7 holes in the top of the can. Pour out the top inch of beer, then spoon the remaining dry rub through the holes into the beer. Holding the chicken upright, with the opening of the body cavity down, insert the beer can into the cavity.
• When ready to cook, if using charcoal, toss half the wood chips on the coals. Oil the grill grate. Stand the chicken up in the center of the hot grate, over the drip pan. Spread out the legs to form a sort of tripod, to support the bird.
• Cover the grill and cook the chicken until fall-off-the-bone tender, 2 hours. If using charcoal, add 10 to 12 fresh coals per side and the remaining wood chips after 1 hour.
• Using tongs, lift the bird to a cutting board or platter, holding the metal spatula underneath the beer can for support. (Have the board or platter right next to the bird to make the move shorter. Be careful not to spill hot beer on yourself.) Let stand for 5 minutes before carving the meat off the upright carcass. (Toss the beer can out along with the carcass.)

BEER CAN CHICKEN WITH MEMPHIS RUB

Steps:

• Remove and discard the fat just inside the body cavities of the chicken. Remove the package of giblets, and set aside for another use. Rinse the chicken, inside and out, under cold running water, then drain and blot dry, inside and out, with paper towels.
• Sprinkle 1 tablespoon of the rub inside the body and neck cavities, then rub another 1 tablespoon all over the skin of the bird. If you wish, rub another 1/2 tablespoon of the mixture between the flesh and the skin. Cover and refrigerate the chicken while you preheat the grill.
• Set up the grill for indirect grilling (see instructions below) placing a drip pan in the center. If using a charcoal grill, preheat it to medium.
• If using a gas grill, place all the wood chips in the smoker box and preheat the grill to high; then, when smoke appears, lower the heat to medium.
• Pop the tab on the beer can. Using a "church key" style can opener, make 6 or 7 holes in the top of the can. Pour out the top inch of beer, then spoon the remaining dry rub through the holes into the beer. Holding the chicken upright, with the opening of the body cavity down, insert the beer can into the cavity. (Caution: the beer fizzes when you add the rub!).
• When ready to cook, if using charcoal, toss half the wood chips on the coals. Oil the grill grate. Stand the chicken up in the center of the hot grate, over the drip pan. Spread out the legs to form a sort of tripod, to support the bird.
• Cover the grill and cook the chicken until fall-off-the-bone tender, 2 hours. If using charcoal, add 10 to 12 fresh coals per side and the remaining wood chips after 1 hour.
• Using tongs, lift the bird to a cutting board or platter, holding the metal spatula underneath the beer can for support. (Have the board or platter right next to the bird to make the move shorter. Be careful not to spill hot beer on yourself.) Let stand for 5 minutes before carving the meat off the upright carcass. (Toss the beer can out along with the carcass.).
• Memphis Rub:.
• Combine all the ingredients in a jar, twist the lid on airtight, and shake to mix. Store away from heat or light for up to six months. Makes about 1/2 cup. Enough for 4 to 6 racks of ribs.
• ** Indirect grilling on a Charcoal Grill:.
• To set up you grill for indirect grilling, light the coals. When they are blazing red, use tongs to transfer them to opposite sides of the grill, arranging them in two piles. Some grills have special half-moon-shaped baskets to hold the coals at the sides; others have wire fences that hook onto the bottom gate. Let the coals burn until they are covered with a thin layer of gray ash. Set the drip pan in the center of the grill, between the mounds of coals. Place the food on the grate over the drip pan, and cover the grill. You'll need to add about 10 to 12 fresh briquettes to each side after an hour of cooking.
• If you want to add a smoke flavor, add 1 to 2 cups of presoaked wood chips, or 2 to 4 chunks, to the coals just before you start to cook, and again whenever you replenish the coals.

BARBECUED BEER CAN CHICKEN

Steps:

• Turn all grill burners to high and close lid to preheat.
• For the spice rub: Mix 2 T. brown sugar, paprika, salt, black pepper and cayenne in a small bowl and set aside.
• For the glaze: Stir 2 T. brown sugar, ketchup, vinegar, beer (take from your beer cans) and hot sauce in a bowl; add 1 T. spice rub; set aside.
• Pour out about 1/2 cup or so from each can of beer. Using a church key can opener, punch holes in the top of the can to completely "open" the top; this will allow maximum steam to escape. Add 2 crumbled bay leaves to each can.
• Loosen the skin on the chicken breasts and thighs of the chicken by sliding your fingers between the skin and the meat. Massage the spice mixture on the skin, under the skin, and inside the cavity. Using a skewer, poke the skin all over to render as much fat as possible while cooking.
• Turn off all but primary grill burners, leaving main burner(s) on high (for my grill, I leave two burners on, but this will depend on how many burners your grill has -- mine has three. The temperature inside your grill should stay around 375). Place chickens on cans; place on cool part of grill, using drumsticks to stabilize them. Cover and grill until skin is very well browned and very crisp, 40 to 60 minutes. Brush with ketchup glaze and grill, covered, until thigh meat registers 170 degrees on instant-read thermometer, about 20 minutes longer.
• Transfer chickens to cutting board and let rest for 10 minutes.

ED'S FAVORITE BEER CAN CHICKEN RUB

Steps:

• Stir brown sugar, dry mustard, granulated onion, paprika, kosher salt, garlic powder, coriander, cumin, black pepper, and cayenne pepper together in a bowl.