Beer Can Chicken With Memphis Rub Food

BEER CAN CHICKEN WITH MEMPHIS RUB

Steps:

• Remove and discard the fat just inside the body cavities of the chicken. Remove the package of giblets, and set aside for another use. Rinse the chicken, inside and out, under cold running water, then drain and blot dry, inside and out, with paper towels.
• Sprinkle 1 tablespoon of the rub inside the body and neck cavities, then rub another 1 tablespoon all over the skin of the bird. If you wish, rub another 1/2 tablespoon of the mixture between the flesh and the skin. Cover and refrigerate the chicken while you preheat the grill.
• Set up the grill for indirect grilling (see instructions below) placing a drip pan in the center. If using a charcoal grill, preheat it to medium.
• If using a gas grill, place all the wood chips in the smoker box and preheat the grill to high; then, when smoke appears, lower the heat to medium.
• Pop the tab on the beer can. Using a "church key" style can opener, make 6 or 7 holes in the top of the can. Pour out the top inch of beer, then spoon the remaining dry rub through the holes into the beer. Holding the chicken upright, with the opening of the body cavity down, insert the beer can into the cavity. (Caution: the beer fizzes when you add the rub!).
• When ready to cook, if using charcoal, toss half the wood chips on the coals. Oil the grill grate. Stand the chicken up in the center of the hot grate, over the drip pan. Spread out the legs to form a sort of tripod, to support the bird.
• Cover the grill and cook the chicken until fall-off-the-bone tender, 2 hours. If using charcoal, add 10 to 12 fresh coals per side and the remaining wood chips after 1 hour.
• Using tongs, lift the bird to a cutting board or platter, holding the metal spatula underneath the beer can for support. (Have the board or platter right next to the bird to make the move shorter. Be careful not to spill hot beer on yourself.) Let stand for 5 minutes before carving the meat off the upright carcass. (Toss the beer can out along with the carcass.).
• Memphis Rub:.
• Combine all the ingredients in a jar, twist the lid on airtight, and shake to mix. Store away from heat or light for up to six months. Makes about 1/2 cup. Enough for 4 to 6 racks of ribs.
• ** Indirect grilling on a Charcoal Grill:.
• To set up you grill for indirect grilling, light the coals. When they are blazing red, use tongs to transfer them to opposite sides of the grill, arranging them in two piles. Some grills have special half-moon-shaped baskets to hold the coals at the sides; others have wire fences that hook onto the bottom gate. Let the coals burn until they are covered with a thin layer of gray ash. Set the drip pan in the center of the grill, between the mounds of coals. Place the food on the grate over the drip pan, and cover the grill. You'll need to add about 10 to 12 fresh briquettes to each side after an hour of cooking.
• If you want to add a smoke flavor, add 1 to 2 cups of presoaked wood chips, or 2 to 4 chunks, to the coals just before you start to cook, and again whenever you replenish the coals.

MEMPHIS RUB BEER CAN CHICKEN RECIPE - (4/5)

Steps:

• Rinse chicken inside and out, drain and pat dry. Sprinkle 1 Tbs. of the rub inside the neck and body cavity, then rub another 1 Tbs. all over the skin of the bird. Pop the tab on the beer can. Using a "church-key"-style can opener, make 6 or 7 holes in the top of the can. Drink or pour out the top inch of beer, then spoon the remaining dry rub through the holes into the beer. Holding the chicken upright, push the chicken down onto the beer can so that the can goes into the cavity. Stand the "stuffed" chicken on a roasting pan. The bottom of the beer can and the two legs from a triangular support. If the chicken is too big and the beer can unstable, buttress the legs with skewers. No trussing or further basting is necessary. Preheat the over to 350. Roast about 2 hours until the skin is crisp and the juices run clear when the bird is poked with the tip of a knife. Allow the finished bird to rest before carving.

BEER CAN CHICKEN

Steps:

• Remove and discard the fat just inside the body cavities of the chicken. Remove the package of giblets and set aside for another use. Rinse the chicken inside and out, under cold running water, then drain and blot dry inside and out, with paper towels. Sprinkle 1 tablespoon of the rub inside the body and neck cavities, then rub another 1 tablespoon all over the skin of the bird. If you wish, rub another 1/2 tablespoon of the mixture between the flesh and skin. Cover and refrigerate the chicken while you preheat the grill.
• Set up the grill for indirect grilling, placing a drip pan in the center. If using a charcoal grill, preheat it to medium. If using a gas grill, place all the wood chips in the smoker box and preheat to high; then when smoke appears, lower the heat to medium.
• Pop the tab on the beer can. Using a 'church key'-style can opener, make 6 or 7 holes in the top of the can. Pour out the top inch of beer, then spoon the remaining dry rub through the holes into the beer. Holding the chicken upright, with the opening of the body cavity down, insert the beer can into the cavity.
• When ready to cook, if using charcoal, toss 1/2 the wood chips on the coals. Oil the grill grate. Stand the chicken up in the center of the hot grate, over the drip pan. Spread out the legs to form a sort of tripod, to support the bird.
• Cover the grill and cook the chicken until fall-off-the-bone tender, 2 hours. If using charcoal, add 10 to 12 fresh coals per side and the remaining wood chips after 1 hour.
• Using tongs, lift the bird to a cutting board or platter, holding a large metal spatula underneath the beer can for support. (Have the board or platter right next to the bird to make the move shorter. Be careful not to spill hot beer on yourself.) Let stand for 5 minutes before carving meat off the upright carcass. (Toss the beer can out along with the carcass.)

PAT'S BEER CAN GRILLED CHICKEN

Steps:

• For the chicken rub: In a small bowl mix all the ingredients together and use for the grilled chicken. You can store extra rub mixture in an airtight container for up to 6 months.
• For the chicken: Preheat your grill to medium-high heat.
• Rub the chicken and its cavity down with the vegetable oil. Season the chicken with rub mixture, remembering to season the cavity. Pour out 1/4 of the beer and sit the chicken on top of the beer can. Place the chicken in the center of the hot grill and cover. Cook the chicken for 1 to 1 1/2 hours, or until an instant-read thermometer registers 165 degrees F. Once cooked, cover loosely with foil and let rest for 10 minutes before carving.

SPICE RUBBED BEER CAN CHICKEN

Steps:

• Heat a gas or charcoal grill with a lid big enough to accommodate the bird. Put a drip pan below the grates.
• Mix the ingredients for the Spice Rub until they are well blended. (This will keep, covered, in the refrigerator for 1 week.) Rub it all over the chicken, inside and out.
• Open the beer and take a big swig or just pour out a couple of ounces. Sit the chicken on the beer can so the legs are at the bottom and the wings are at the top. Stand the beer can on the grates over the drip pan. Put the cover on and cook over indirect heat until the juices run clear, about 1 hour. (If using charcoal, push the coals to 1 side so the chicken is not over direct heat.)
• Note: This chicken can also be cooked in a 350 degrees F oven. Just stand the beer can in a shallow roasting pan and cook about 1 hour or until juices run clear.

TEXAS DRY RUB BEER CAN CHICKEN

Steps:

• In a small bowl combine the rub ingredients.
• Remove and discard the neck, giblets, and any excess fat from the chicken. Rinse the chicken, inside and out, under cold water and pat dry with paper towels. Lightly spray or brush all over with the vegetable oil and season, inside and out, with the rub. Let rest at room temperature while you preheat your grill.
• Open the beer can an pour off half of the beer. (Or drink it if you don't want to waste it.) Set the half-full can of beer in can holder (or if you don't have a can holder, just be extra careful and place the can on a flat smooth surface), and add fresh rosemary leaves, minced shallot and lemon juice. This will help add moisture and flavor from the inside as your chicken cooks. You may need to use a funnel, to help add the ingredients to the can.
• Slide the chicken over the top so the can fits inside the cavity. Transfer the bird to your preheated grill, while carefully keeping the can upright. Carefully balance the bird on its two legs and the can holder. (If can holder is not used just use the can and use the legs like a tripod.) Grill over Indirect Medium heat until the juices run clear and the internal temperature reaches 170 F in the breast and 180 F in the thickest part of the thigh. 1 - 1/4 to 1 - 1/2 hours. Wearing barbecue mitts, carefully remove the chicken and the can (holder) from the grill. Do not spill the beer, it will be HOT. Let the chicken rest for about 10 minutes before lifting it from the can (holder). Discard the beer. Cut the chicken into serving pieces. Serve warm.
• ENJOY!

BARBECUE RUB FOR BEER CAN CHICKEN

Steps:

• Combine all ingredients and store in airtight container.

BEER CAN CHICKEN

Steps:

• If making the rub:
• Combine all the ingredients in a jar, twist the lid on airtight, and shake to mix. Store away from heat or light for up to six months. Makes about 1/2 cup. Enough for 4 to 6 racks of ribs.
• Remove and discard the fat just inside the body cavities of the chicken. Remove the package of giblets, and set aside for another use. Rinse the chicken, inside and out, under cold running water, then drain and blot dry, inside and out, with paper towels. Sprinkle 1 tablespoon of the rub inside the body and neck cavities, the rub another 1 tablespoon all over the skin of the bird. If you wish, rub another 1/2 tablespoon of the mixture between the flesh and the skin. Cover and refrigerate the chicken while you preheat the grill.
• Set up the grill for indirect grilling (see below) placing a drip pan in the center. If using a charcoal grill, preheat it to medium.
• If using a gas grill, place all the wood chips in the smoker box and preheat the grill to high; then, when smoke appears, lower the heat to medium.
• Pop the tab on the beer can. Using a "church key" style can opener, make 6 or 7 holes in the top of the can. Pour out the top inch of beer, then spoon the remaining dry rub through the holes into the beer. Holding the chicken upright, with the opening of the body cavity down, insert the beer can into the cavity.
• When ready to cook, if using charcoal, toss half the wood chips on the coals. Oil the grill grate. Stand the chicken up in the center of the hot grate, over the drip pan. Spread out the legs to form a sort of tripod, to support the bird.
• Cover the grill and cook the chicken until fall-off-the-bone tender, 2 hours. If using charcoal, add 10 to 12 fresh coals per side and the remaining wood chips after 1 hour.
• Using tongs, lift the bird to a cutting board or platter, holding the metal spatula underneath the beer can for support. (Have the board or platter right next to the bird to make the move shorter. Be careful not to spill hot beer on yourself.) Let stand for 5 minutes before carving the meat off the upright carcass. (Toss the beer can out along with the carcass.)

ED'S FAVORITE BEER CAN CHICKEN RUB

Steps:

• Stir brown sugar, dry mustard, granulated onion, paprika, kosher salt, garlic powder, coriander, cumin, black pepper, and cayenne pepper together in a bowl.

MEMPHIS RUB BY STEVEN RAICHLEN

Steps:

• Mix all ingredients together, using the cayenne pepper to your heat preference.
• Rub on a whole chicken for beer can chicken, or a rack of ribs.
• Makes about a half a cup of rub.

MEMPHIS RUB

Steps:

• In a small airtight container, mix paprika, dark brown sugar, white sugar, salt, monosodium glutamate, celery salt, ground black pepper, cayenne pepper, dry mustard, garlic powder and onion powder. Seal and store in a cool dark place until ready for use.