Walnut Rye Sourdough Bread Food

SOURDOUGH BREAD

Steps:

• For the levain: Combine the all-purpose flour, whole-wheat flour, water and starter in a medium bowl and mix to combine. Cover and let sit at room temperature until bubbly and increased in volume by about 20 percent, about 8 hours.
• For the dough: Add the all-purpose flour, water and whole-wheat flour to the bowl of a stand mixer fitted with a dough hook. Weigh out 7 ounces of the levain (about 1 cup) and add to the mixer (discard any remaining levain). Mix on low until a shaggy dough forms. Cover the bowl and let sit at room temperature for 30 minutes.
• Add the salt to the dough and mix on medium speed for 2 minutes; the dough should feel a bit sticky and wet but look smooth and very stretchy. Scrape the dough into a plastic or glass container about twice its size. Cover and let sit at room temperature until puffed, about 45 minutes.
• Put the dough on a floured work surface, flatten it gently, then fold in thirds like a business letter. Transfer it back to the container. Cover and let sit at room temperature for 45 minutes.
• Repeat the folding process one more time, transfer back to the container, cover and let sit at room temperature for another 45 minutes. After the third 45-minute rest, the dough should feel soft and pillowy; when pressed with a finger, it should leave an indentation that begins to spring back.
• Gently scrape the dough onto a lightly floured work surface. Divide in half using a bench scraper. Shape each piece loosely into a round by gently tucking the edges under. Cover with a kitchen towel and let rest for 30 minutes.
• Drape 2 kitchen towels into 2 medium (8-inch) bowls and dust very generously with flour. Dust the top of the dough rounds very lightly with flour and flip over using a bench scraper. Flatten one piece of dough into a circle, then fold the left and right sides of the dough over the center. Keeping tension in the dough, begin folding down from the top edge in 3 segments, sealing the bottom edge with the last fold. Loosely cup the dough and, using your hands and the tension between the board and the dough, pull the bread very slowly towards yourself while creating a taut ball. Gently flip the dough ball over and into one of the prepared bowls. Cover loosely with another kitchen towel. Repeat the process with the second piece of dough. Place both in a warm place to rise until about 1 1/2 times their size, 2 to 2 1/2 hours.
• About 20 minutes before baking, position an oven rack in the lower third of the oven, put a 4-quart Dutch oven and lid on the rack and preheat to 500 degrees F. When preheated, carefully transfer the hot Dutch oven to a heatsafe surface with oven mitts (leave the lid in the oven). Flip one round of dough over into the Dutch oven. Using a sharp knife, scissors or bread lame, score the top of the bread in a cross or desired pattern. Return to the oven, immediately cover with the lid and bake for 20 minutes. Lower the temperature to 425 degrees F, uncover and bake until dark brown, about 10 minutes more. Transfer the bread to a cooling rack to cool completely. Return the empty Dutch oven to the oven, raise the temperature to 500 degrees F and let heat for 10 minutes before repeating the baking process with the second dough round.

SOURDOUGH BREAD: 100% SOURDOUGH RYE BREAD

Steps:

• The day before making the dough, make the rye starter. Mix together the barm and rye flour in a bowl, adding only enough water to form a ball. It should be firm and a little tacky but not sticky or spongelike. Work quickly. It is not necessary to develop the gluten, only to hydrate all the flour and form a shaggy but firm dough. Lightly oil a bowl and transfer the starter to the bowl, rolling it around to coat it lightly with the oil. Cover the bowl with plastic wrap.
• Ferment at room temperature for 4 hours or longer, or until the dough doubles in size (it will become softer and stickier as it rises). Refrigerate overnight.
• Also on the day before making the final dough, make the soaker. Combine the coarse rye flour and water in a bowl. Cover the bowl with plastic wrap and let it sit at room temperature overnight.
• The following day, remove the rye starter from the refrigerator 1 hour before making the dough. Cut the starter into about 10 small pieces with a pastry scraper or serrated knife. Mist with spray oil, cover the pieces with a towel or plastic wrap, and let sit for 1 hour to take off the chill.
• To make the final dough, stir together the rye flour, salt, and seeds in a 4-quart mixing bowl (or in the bowl of an electric mixer). Add the soaker and the starter pieces. With a large metal spoon, stir in enough lukewarm water to bring everything together to form a ball (or mix on low speed with the paddle attachment).
• Sprinkle rye flour on the counter and transfer the dough to the counter. Sprinkle the dough with more rye flour and gently knead the dough until all the pieces of starter are assimilated into the dough and the dough forms a very tacky ball (or mix on medium speed with the dough hook). This will take 5 to 6 minutes by hand (4 minutes by machine). Add flour as needed (or small amounts of water if the dough is tight). Let the dough rest on the counter for 5 minutes, and then give it a few more turns to complete the kneading. It should register 77° to 81°F. (This dough will not make a good windowpane when stretched because of the low gluten content.) Lightly oil a large bowl and transfer the dough to the bowl, rolling it around to coat it with oil. Cover the bowl with plastic wrap.
• Ferment for approximately 4 hours, or until the dough nearly doubles in size.
• Sprinkle rye flour on the counter and transfer the dough to the counter, being careful to degas it as little as possible. Divide the dough into 2 equal pieces, sprinkle them with rye flour, and gently shape them into bâtards. Line a sheet pan with baking parchment and sprinkle the parchment with coarse rye flour, semolina flour, or cornmeal. Place the loaves on the pan at least 4 inches apart. Mist the dough with spray oil and cover loosely with plastic wrap.
• Either proof the dough for 2 hours at room temperature or slip the entire pan into a food-grade plastic bag and immediately refrigerate overnight. If you are holding the dough overnight, remove the pan from the refrigerator 4 hours before baking and proof the dough at room temperature, or until about 1 1/2 times its original size. It will have spread sideways as well as upward.
• Prepare the oven for hearth baking as described on pages 91-94, making sure to have a steam pan in place. Preheat the oven to 500°F. Remove the pan from the bag or lift off the plastic, and let the dough sit exposed for 5 minutes, then score it.
• If you are baking on a stone, slide the parchment and dough onto the back of a sheet pan or onto a peel and then transfer it to the stone (or bake the bread directly in the sheet pan on which it was rising). Pour 1 cup hot water into the steam pan and close the door. After 30 seconds, mist the oven walls with water and close the door. Repeat twice more at 30-second intervals. After the final spray, lower the oven setting to 425°F and bake for 10 minutes. Rotate the loaves 180 degrees, if necessary, for even baking and continue baking for another 10 to 15 minutes, or until done. The internal temperature should register approximately 200°F and the crust should be hard and somewhat coarse (it will soften as the bread cools).
• Transfer the breads to a rack and let them cool for at least 1 hour before slicing or serving.
• Lean, standard dough; indirect method; wild yeast
• Day 1: 4 to 5 hours firm rye starter and soaker
• Day 2: 1 hour to de-chill starter; 6 minutes mixing; 6 hours fermentation, shaping, and proofing; 25 to 30 minutes baking
• The bread is best when made with a variety of grinds, from fine white rye to coarse pumpernickel or even rye chops (cracked rye kernels). This version uses a blend and also utilizes the soaker method to condition the grain and develop enzyme activity.
• If you make rye bread regularly, you can keep a rye barm on hand in addition to your regular barm. Otherwise, you can use your regular barm starter and turn it into a rye starter, but it will contain a proportion of wheat. To make a pure rye-only starter, consult the Commentary on page 229.
• Allow 3 days to make this bread (or start early on the second day to bake it around dinnertime). Because it is low in gluten, the bread will have a fairly tight crumb, not large and irregular as with standard hearth breads. The dough is slightly softer than French bread, but not as wet as ciabatta and other rustic doughs. This added hydration provides some physical leavening (steam) in support of the biological (wild-yeast) leavening provided by the starter. The result is a relatively dense loaf with a long shelf life.
• This same formula also can be used for making spelt bread, another wheat relative that is lower in gluten (mainly it is lower in gliaden, which is the offensive half of gluten to those with sensitivities). Just substitute spelt for rye and follow the same directions.
• As always with rye breads, the use of caraway, anise, or other seeds is optional. This bread is delicious with or without them.
• 100% Sourdough Rye Bread %
• (FIRM RYE STARTER)
• Barm: 77.8%
• White rye flour: 100%
• Water (approx.): 44.4%
• Total: 222.2%
• (SOAKER)
• Coarse rye flour: 100%
• Water: 200%
• Total: 300%
• (FINAL DOUGH)
• White rye flour: 100%
• Firm rye starter: 74.1%
• Soaker: 44.4%
• Salt: 2.8%
• Caraway seeds: 3.7%
• Water (approx.): 51.9%
• Total 276.9

WALNUT RYE BREAD

Steps:

• add ingredients (EXCEPT NUTS) to your bread machine in this order.
• set loaf size, crust and bake on whole wheat or fruit/nut cycle.
• after 5 minutes check to see that dough is in a smooth ball.
• if too dry add water 1 tsp at a time, if too wet add flour 1 tsp at a time.
• add nuts when machine beeps, or at the end of the cycle.
• cool on a rack before slicing.