Sourdough Starter As Made By Johnny Vancora Recipe By Tasty Food

SOURDOUGH STARTER RECIPE BY TASTY

Steps:

• Day 1: Add 50 grams whole wheat flour, 50 grams bread flour, and 100 grams warm water to a clear lidded container with a capacity of 1 pint or more. Mix until there are no dry spots. Scrape down the sides of the container with a spatula. Cover with a lid.
• Use a rubber band or piece of tape to mark the mixture level. This will allow you to track any movement (eventually it will grow!) Set the starter in a warm spot. Let sit for 24 hours.
• Day 2: After 24 hours, open the container and look for signs of fermentation in the form of bubbles on top, volume growth, and/or a funky, slightly sweet acidic smell. If you see some of these signs, proceed to the next step. If not, cover the starter again and let sit for another 12-24 hours, until these signs appear. If the temperature in your house is cool, it may take a bit longer.
• Once the starter has gotten a bit bubbly and funky, it is time to discard and feed. Discard all but about 25 grams (2 tablespoons) of starter (see Note below on how to minimize waste!). Add another 100 grams warm water and stir to dissolve the remaining starter. Add 50 grams of bread flour and 50 grams of whole wheat flour and stir until there are no dry spots. Cover and let sit in a warm spot for another 24 hours.
• Days 3-15: Repeat the feeding process every day for 7-14 days. Eventually, a few hours after feeding, the starter will begin to grow, almost doubling in size, then deflate again. Once your starter is rising and falling regularly, it is in a good place.
• To test the readiness of the starter, do a float test: Fill a cup with cool water. Use a clean spoon to take a scoop of the starter (be careful not to stir the starter and deflate the air bubbles that make it float) and carefully plop it in the water. If it floats, it is gassy and alive and ready to make some bread! If not, don't despair, it can take a while to get going. Either wait longer if it has only been a few hours since feeding, or if it has been closer to 24 hours since feeding, discard and feed again.
• After passing the float test, the starter is ready to use for baking! You may find you like to use your starter when it is young, only a few hours after feeding when it just passes the float test. At this point it will smell sweet. If you want a more sour taste, use the starter 6-12 hours after feeding, when it will be more mature and smell a bit more vinegary and funky. This is up to you!
• Mold: If you see any fuzzy moldy spots on your starter that are black, red, or blue, unless it is very easy to scrape them off the top, unfortunately you need to start over. Sometimes, a while after feeding or being in the refrigerator, the starter will develop a dark, clear liquid on top. This is called hooch and is harmless. Just pour the liquid off!
• Flour: Use what you have. If you only have all-purpose flour, you can use that. If you only have bread flour, use that. If you only have whole wheat flour, you can use that, just know that you may need to feed more often because it gets funky more quickly.
• Discard: It may be tempting not to discard most of your starter every time you feed it because you don't want to waste, but we discard for a variety of reasons. We are giving the starter a lot of fresh food and water to eat. If we don't discard, the starter will retain a lot of that funkiness and also eventually grow to be huge if you just keep adding water and flour to it. I like to discard into another container and keep that container in the refrigerator until I need it for other baking projects. You can fold the discard into banana bread, pancakes, cookies, etc.
• Storage: Once your starter is up and running, you can either keep it at room temperature and feed it daily, or store it in the refrigerator. To store in the refrigerator, do a regular discard and feed, then place in the refrigerator. A day before you want to begin making bread, pull the starter out and let it come to room temperature. Then, discard and feed as usual.
• Scaling: This starter recipe calls for equal amounts of water and total flour by weight. You can scale this recipe up or down as needed, depending on how much starter the recipe you are going to make calls for.
• Enjoy!

CHEF JOHN'S SOURDOUGH STARTER

Steps:

• Day 1: Mix 70 grams flour and 70 grams water together in a container with a lid. Container needs to be large enough to accommodate another 70 grams water and flour. Cover loosely so gases can escape. Leave for 24 hours at 70 degrees F.
• Day 2: Add 70 grams flour and 70 grams water. Stir. Cover loosely and leave for 24 hours at 70 degrees.
• Day 3: Remove half (140 grams) of the starter. Add 70 grams flour and 70 grams water. Stir. Cover loosely and leave for 24 hours at 70 degrees.
• Day 4 through about Day 10: Repeat Step 3 each day until starter smells fruity, yeasty, and is beautifully fermented. You can test this by seeing if the mixture doubles within 2 to 3 hours of feeding.
• Refrigerate until needed. Most people recommend you feed the starter once a month or so (Step 3).
• To make bread using a refrigerated starter: feed it at room temperature for two days. Use your refreshed starter to make bread on the third day. Remember to set aside 140 grams of starter and feed it again before returning it to the fridge.

SOURDOUGH STARTER

Steps:

• Day 1:To begin your starter, mix 50g flour with 50g tepid water in a jar or, better still, a plastic container. Make sure all the flour is incorporated and leave, semi-uncovered, at room temperature for 24 hrs.
• Day 2:Mix 50g flour with 50g tepid water and stir into yesterday's mixture. Make sure all the flour is incorporated and leave, semi-uncovered, at room temperature for another 24 hrs.
• Day 3:Mix 50g flour with 50g tepid water and stir into yesterday's mixture. Make sure all the flour is incorporated and leave, semi-uncovered, at room temperature for another 24 hrs.
• Day 4:You should start to see some activity in the mixture now; there should be some bubbles forming and bubbling on top. Mix 50g flour with 50g tepid water and stir into yesterday's mixture. Make sure all the flour is incorporated and leave, semi-uncovered, at room temperature for another 24 hrs.
• Day 5:The mixture should be very active now and ready for making your levain (starter). If it's not bubbling, continue to feed it on a daily basis until it does. When it's ready, it should smell like yogurt.
• You now have a starter, which is the base to the bread. You'll need to look after it, but naming is optional! Keep it in the fridge (it will stay dormant) and 24 hrs before you want to use it, pour half of it off and feed it with 100g flour and 100g water. Leave it at room temperature and it should become active again. The longer the starter has been dormant, the more times it will need to be refreshed - the process of pouring off half the starter and replacing it with new flour and water - to reactivate. If your starter is ready to use, a teaspoonful of the mixture should float in warm water.The starter can now be used to make white sourdough bread.