Haunted Castle Cake Food

EASY CASTLE CAKE

Steps:

• Heat the oven to 160C/140C fan/gas 3. Grease and base line a round 13cm cake tin and a round 18cm cake tin. Place two muffin cases in a muffin tin.
• Put the butter and sugar into a large bowl and beat together until light and creamy. Add all the remaining ingredients except the jam and beat well. Half fill the muffin cases and then fill the two cake tins 3/4 full. Bake in the oven placing the cake tins on one shelf and the muffin tin on another. Open the oven door and remove the muffins and smaller cake quickly when they are done as you don't want to let the heat out of the oven. The muffins will take about 35 mins, the 13cm cake about 1 hour 10 mins and the 18cm cake about 1 1/2 hours. You know each is done when a skewer inserted into the centre comes out clean. Allow the cakes to become completely cold before icing.
• Trim the tops of the two cakes so they are flat. Slice each one in half, spread with jam and then sandwich together again. Using a 6cm cutter, cut each muffin to make a cylinder. Trim the tops flat. Sandwich together with jam to make a tower.
• To make the butter icing put the butter into a bowl and beat until soft. Gradually beat in the icing sugar. Spread the butter icing over both cakes and the muffin tower. Roll out the white icing and use to cover the two cakes. Place the larger one on a cake board. Put the smaller one on top. Roll a strip of white icing and wrap around the muffin tower. Place on top of the cake. Push a wooden skewer though the cakes to hold them together.
• Using about 150g pink icing, mould into an onion shape for the dome. Put to one side. Roll out a little pink icing and cut out a 6cm round and place on top of the muffin tower. Using the made up royal icing, attach the dome to the top of the tower.
• Using the pink icing make two doors and two curtains. Attach to the cake using royal icing. Make windows by rolling out the lilac icing and cutting out hearts using medium, small and tiny cutters. Attach these upside down to the cake with royal icing. Roll a small piece of lilac icing into a thin sausage and stick around the curtains to make the window frame.
• Again using the royal icing, stick on the pieces of gum around the doors, and the sugar cubes around the edge of the cakes. Attach silver balls to the dome to decorate and to the doors to make handles. Score horizontal lines down the doors to give a textured effect. Attach a piece of gum under each window on the middle tier and then stick three flowers on top to make window boxes.
• Colour the remaining royal icing green and spoon into a piping bag fitted with a plain nozzle. Pipe creeper branches up the castle walls. Attach mini sugar flowers.
• Stick coloured flags or candles into the middle tier of the cake. Sprinkle a little edible glitter over the dome and sugar cubes.

HAUNTED CHOCOLATE CASTLE

Steps:

• Make the base: Use an 18 to 20-inch diameter bowl that is about 6 inches deep. Press a large sheet of tin foil into the side of the bowl. This will create a great texture. Use a pastry brush dipped in dark chocolate to coat the tin foil. Do not press too hard with the brush or you will lose the texture of the aluminum. Repeat this step 3 or 4 more times until the chocolate layer is about 3/8-inch thick. When the chocolate has set, invert the bowl to release the base from the bowl. Carefully peel the tin foil away from the chocolate. Set aside. Make the rooftops: Make a cone out of a sheet of acetate securing it closed with tape. Use a scissor to trim the edge of the cone so the end is straight. You will need 1 cone for each castle turret. The cones I made were about 9-inches tall and ranged in the opening diameter from 1 to 4 inches. Tip: Determine the size of the turrets you will make so you can coordinate cone rooftops that match the size. Use a ladle to fill the cone with chocolate. When it is full, empty it into the bowl of chocolate. The inside of the cone should be evenly coated with chocolate. Wipe the edge of the plastic cone clean on the side of the bowl and place it upside down on a wire rack placed over a baking sheet. Once the chocolate starts to harden, about 5 minutes, scrape the edge of the cone clean with a paring knife. You can place the cone in the refrigerator for several minutes to help the chocolate to harden. Repeat 3 more times to make 4 rooftops. When the chocolate sets, peel off the acetate. Set aside. Make the turrets: The tallest turrets of my castle are made with tubes of chocolate, each a different size in diameter. Each turret is also made of tubes of 2 different diameters. I made 5 turrets plus an extra large turret. I call the largest turret the main house. It is an irregularly shaped tube but the technique to make it is different from the other turrets. To make the main house, roll a long piece of acetate to determine the size of the tube you would like to make. Use a marker to mark the place on the acetate that indicates the desired diameter. Unroll the acetate and place a piece of parchment at the mark to cover the extra acetate. Use an offset spatula to spread a 1/4-inch-thick layer of tempered chocolate over the exposed sheet of acetate. Let the chocolate set slightly then roll the open end toward the parchment line. When the open end meets the parchment, continue to roll the extra acetate and tape it closed. Use a tin can to press this tube into an irregular shape. When the chocolate is set, peel off the acetate. Use a hot knife to shape the top edge of this piece. Use a slow sawing motion. If you see smoke, the knife is too hot. Dip the end of this piece into the tempered chocolate and adhere it onto the base.
• To make the tall turrets, use the following technique to make chocolate tubes. Roll a tube to the desired diameter and secure it closed with tape. The turrets on my castle range from 1 to 5 inches in diameter. Tape 1 end of the tube closed with tape. Set the tube on end and fill with chocolate. When it is full, invert the tube over the bowl of chocolate allowing the excess chocolate to flow back into the bowl. Let set. When the chocolate has set, repeat this step a few more times. You want the tubes sturdy so the castle will be strong. Allow the chocolate tube to set until hard. Remove the acetate. The largest tube gets cut into pieces to make the base of some turrets. Use a hot knife to cut all of the tubes into unequal sizes. To do this, heat the knife under very hot water and wipe it dry. Hold the knife blade against the side of the chocolate where you want to make the cut. Do not press on the knife or the chocolate will break. Allow the heat of the knife to "cut" through the chocolate by melting it. To assemble the turrets: Start with the largest diameter planned for each turret and use tempered chocolate to adhere the piece to the base. Combine different size tubes to make the tall turrets. Use tempered chocolate to glue the turret pieces together. Apply the chocolate at the top of the base turret and at the bottom of the tube inserted into that base. Use cold spray or hold it until the chocolate sets. Make a cornet and fill it with tempered dark chocolate. Starting with the tube of greatest diameter, place the next smallest diameter tube piece inside it and use the cornet to "glue" the 2 pieces together. If you have cold spray, it will be helpful to use it here. Continue this process using 2 or 3 different diameter tubes for each turret. Then repeat the process to make a total of 5 turrets. Use a hot cutter to make the windows. Heat the cutter with a blowtorch or hold it under very hot water and wipe it dry. Hold the cutter against the chocolate where you want to make the cut. Do not press too hard or the chocolate will break. Allow the heat of the metal to "cut" through the chocolate by melting it. At this stage, you can spray the castle to give it a great texture. The trick is that you have to be able to fit the castle into your freezer. Place the castle in the freezer for about 15 to 20 minutes. The surface of the chocolate must be chilled so the chocolate coating will harden upon contact, giving it the desired texture. Prepare the paint sprayer: Place equal amounts of chocolate and cocoa butter over a double boiler and melt until smooth (no lumps).
• Remove the presentation from the freezer and place on a parchment paper lined surface. Place the chocolate mixture in a clean paint sprayer and use it to spray the dessert with the chocolate. Tip: Anything that touches the tubes after they have been sprayed will leave a mark. Use tempered chocolate to secure a rooftop to the top of each turret. Make the trees: Make a cornet and fill it with tempered dark chocolate. Draw a tree onto a sheet of parchment paper. Repeat the same technique to make as many trees as you would like. Let your imagination run wild as you draw scary trees. When the chocolate sets, lift it from the parchment paper. If it sticks, you can loosen it with a paring knife. Make the bats: Use a spoon to fill the bat molds with chocolate. Once the chocolate starts to harden, about 5 minutes, check to be sure the edges of the mold are clean and if necessary, clean with a paring knife. When the chocolate sets, it shrinks or retracts from the sides of the mold. A clean edge will keep it from sticking and cracking as it shrinks. You can place the mold in the refrigerator for several minutes to help the chocolate to harden. Repeat to make as many bats as you would like. I made mine about 7 inches tall. Make the turret squares: Use an offset spatula to spread a 1/4-inch-thick layer of tempered chocolate over a sheet of textured acetate. Let the chocolate set slightly. Wait until the chocolate begins to set. Use a rolling cutter or hot sharp chef's knife to cut rectangles that are 1-inch by 2 inches. When the chocolate has set, carefully peel away the sheet. It should release from the chocolate quite easily. Finishing details: Use tempered chocolate to attach the turret squares to the top of each turret. Glue the trees and bats in place. Use the tip of a metal skewer to poke holes in the base of the castle. Insert the chocolate lollipops into these holes.

HAUNTED-HOUSE CAKE

Steps:

• To assemble the cake: Secure one 11-inch cake layer to corresponding-size round foam board with a dab of chocolate buttercream. Spread 2 cups buttercream on top. Stack another 11-inch cake on top of buttercream, and frost as before. Top with remaining 11-inch cake. Spread 1 cup buttercream over top and sides of tier, scraping lightly to create a thin layer, or crumb coat, and refrigerate until frosting is firm, about 30 minutes. Spread 2 cups buttercream over entire tier until smooth.
• Repeat with 9-inch cake layers on second foam board, using 1 cup frosting between layers, 1/2 cup for crumb coat, and 1 cup for the final coat.
• Trim 5 dowels to height of 9-inch tier and 6 to height of 11-inch tier. Insert dowels in corresponding tiers in a circle, 2 1/2 inches from the edge of cake. Center 9-inch tier over 11-inch tier, pressing gently to secure. Fill a pastry bag fitted with a 1/2-inch plain tip (#806) with remaining buttercream. Pipe pearls around bottoms of tiers for a border, as shown below. (Cake can be refrigerated up to 3 days before proceeding.)
• Make the steps: Fill a small bowl with cocoa powder. Cut torrone into 2-to 2 1/2-inch-long blocks. Cut toothpicks in half (1 for each block). Roll torrone in cocoa powder to coat. Insert toothpicks into torrone blocks, and push blocks into cake, starting from top of 9-inch tier and curving to bottom of 11-inch tier. Using a vegetable peeler, shave milk chocolate; sprinkle over tops of tiers.
• Finish the cake: Carefully transfer assembled cookie house to top of cake. Press cookie doors into cake in front of house. Decorate cake with cookie tree, tombstones, and candy cats, if desired. Press caretaker cutout onto top of cake, behind door. Arrange a flashlight behind cake to shine through door and windows.